http://www.kawasakiversys.com/forums/showthread.php?t=3155

Here you go. Post #8 for me. Love the set up as well.

 

thanks bro, the mirrors I have actually bolt to the end of the bar, i was looking at the Barkbusters VPS Handguards...the TwistedThrottle page states that you must purchase the Versys End Weights but I bet I could rig something half the width of these End Weights and slip the Mirrors in between.

 

Go to this thread. http://www.kawasakiversys.com/forums/showthread.php?t=5352 I just posted a picture of my Versys. Bar end mirrors and Cyra Pro Bend hand guards.

 

That's perfect, thanks bro! I will prolly be able to rig a nice shim in between the mirror and guard bar.

 

Those are BikeMaster (TANAX) Napoleon from BikeBandit. You don't need a shim, just cut off the keyed tube that runs through the rubber to about 3/8" past the metal plate and rubber cap. Bevel the keyed part a little so it will not quite bottom out in the recess in the end of the hand guard bar. Use the bolt that comes with the mirror to screw into the stock handlebar. You will need to trim the rubber covers that go on the end of the hand guard bars. You can turn them in so you can see the edge of your top box and still not see your arms or shoulders They also flip to six positions so you can flip them in so they don't extend beyond the bar ends. Handy in the garage.
I can post a better picture of the mounting if needed. I didn't post the original picture to showcase the mirrors.