I ordered some axle sliders for my little X300 with the hope of making servicing the wheels (spokes) and other stuff easier. The only problem is that the cotter pins for the castle nuts on each axle won't be able to go back in on the slider shafts are installed. I have researched a self-locking style nut that would allow the pass through, but haven't come up with much. I imagine someone else has already put some of these in and any advice would be appreciated!
Bedtime Sneakers
I'm an idiot. I emailed their support and the sliders come with instructions on what to do. Will post pics once completed (comes in tomorrow) for folks who may also be interested.
Easy peasy kit. No instructions as advertised, but not necessarily needed. They include a locknut to replace the factory castle nut and cotter pin. You them thread the line through and put the cap on, tighten both sides with a 10mm and be on your way. There are certainly worse ways to spend $75.
Link for parts:
https://www.t-rex-racing.com/searchresults.asp?Search=Versys-X+300+Axle&Submit=
My only gripe is I wish they used the same size blocks on both sides of the rear spool.
Link for parts:
https://www.t-rex-racing.com/searchresults.asp?Search=Versys-X+300+Axle&Submit=
My only gripe is I wish they used the same size blocks on both sides of the rear spool.
Attachments
May I ask what axle sliders do?
If it is this
My engine guard, top box and handguards are the only bits that touched.
Maybe useful on another model but VersysX?
If it is this
then i have to wonder.
My engine guard, top box and handguards are the only bits that touched.
Maybe useful on another model but VersysX?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
