Kawasaki Versys Forum banner
1 - 4 of 4 Posts

·
Registered
'09 Versys 650
Joined
·
9 Posts
Discussion Starter · #1 · (Edited)
I'm 6'2" 190lb, 34" inseam. Previous owner of this '09 Versys 650 was short (5'2") and...big-boned. The seat makes my tailbone hurt after about 45 minutes.

Looking to trade a motowerk rear suspension lowering kit and lowered stock seat for a good aftermarket seat (for my height). The previous owner shaved a few mm off the stock seat in a "contour" for a butt that is larger than mine and the decreased amount of foam doesn't work for me.

Would also consider trading lowered side stand with flat foot peg for a stock or aftermarket side stand.
Auto part
Auto part
Land vehicle Vehicle Motorcycle Motor vehicle Car
Land vehicle Vehicle Motorcycle Motor vehicle Car
 

·
Super Moderator
Joined
·
20,798 Posts
I have a set of stock seat-foams for the V650 seat, that I got a few years back - if you want them (they are UNSHAVED!) - $20 plus postage, OR TRADE for the "lowering kit". PM me.

IMG_0449 by Ed Copeman, on Flickr

IMG_0450 by Ed Copeman, on Flickr

IMG_0451 by Ed Copeman, on Flickr
 

·
Registered
Joined
·
14 Posts
I would be interested in your seat foam if you still have it. I have a pair of (I believe Moto Werks) footpegs lowering blocks, I removed from a 2009 Versys I bought this Summer. Bob in Yakima, Washington.
Grey Household hardware Fastener Nut Automotive engine part
 
1 - 4 of 4 Posts
Top