Kawasaki Versys Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,276 Posts
Discussion Starter #1
I KNOW I've seen it discussed here but can't for the life of me find the threads....:mad::mad: about changing out the Versys oil pan for the ER6N pan to get rid of the low hanging oil drain spout. Can anyone point me in the right direction, PLEASE? And Thank You :wink2:
 

·
Super Moderator
Joined
·
19,629 Posts
Jeff - I think the whole job just entails 1. draining the oil; 2. removing all the pan-bolts, then the pan; 3. installing the new pan (SAME pan on the Gen 3 Vs) w/ a GOOD gasket; and 4. re-fill the oil.
 

·
Registered
Joined
·
972 Posts
The factory skid plate (the exhaust system) on my 2015 pretty much protects the engine. It's two inches or so below anything vital.
 

·
Registered
Joined
·
1,276 Posts
Discussion Starter #5
HEY.........Wait a minute :surprise::surprise:
I found THAT thread within 5 minutes :grin2: I was more looking for information on specifics of the swap and any associated modding that needed to be done.
Dave (JDRocks) hooked me up with all the pertinent info, thanks!
 
1 - 5 of 5 Posts
Top