Kawasaki Versys Forum banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
16,402 Posts
I have a Givi topcase with brakelights and turn signals that I am trying to hook up. The connector has only two wires. How do I wire them to my 2009 Versys 650? What color wire am I looking for?

I had a 2009....
Heres all i know about the wires. I used the tail light wire to tap into for my switched juice for my Garmin Zumo......

Red Wire is Tail Light

Blue Wire is Brake Light

Green Wire is Right Turn Signal

Yellow Wire is Left Turn Signal
 

·
Premium Member
Joined
·
16,402 Posts
Hey guys, thank you very much for the great advice. I have confirmed the Givi z880 wiring harness has only two wires, and is only for brakes.

The installation instructions for the Givi products seem to be pretty weak, but I got this from [email protected]:

The Z880, and GIVI’s brake light kit, only work as a brake light. If you wish the turn signals to work as well, you might look a company called Ad-more Lighting which has a kit for the E55 but does not use the Z880.

So the $139 kit from Ad-more Lighting adds turn signals to the Givi E55 topcase, and has SIX WIRES:
E55 Top Case - LED Kit (TS)

I have the Admore Light Kit for my E-55 and also have the Admore Light Bar. If i had to only have one i would choose the light bar.

Heres the info on the light bar which is the same for the light kit...

Untitled by weljo2001, on Flickr
 

·
Premium Member
Joined
·
16,402 Posts

·
Premium Member
Joined
·
16,402 Posts
so the light bar goes above the license plate? It looks like it would really help visibility.

At first i had the light bar connect under the Givi Rack then moved it to the license plate. Did the same placement on my FJR...Photos below. In the 4th photo you want to pull the light bar out some so it doesn't block the license plate light from shining on the plate. I have the Large light bar on the Versys and FJR. They make a smaller one also


Untitled by weljo2001, on Flickr

Untitled by weljo2001, on Flickr

Untitled by weljo2001, on Flickr

Untitled by weljo2001, on Flickr

Untitled by weljo2001, on Flickr
 

·
Premium Member
Joined
·
16,402 Posts
These guys should hire you to do their advertising. Pretty sweet. And that's quite a nice ride too. The light bar is like police car flashing on a dark highway. It really draws your attention. How do you think that compares to AdMore LED55-T-TS Light Kit (for the Givi E55)?
Heres an old video of my Versys with the Admore Light Kit in my Givi E-55 Top Case and an Admore Light Bar mounted under the Givi Top Case Rack...

 

·
Premium Member
Joined
·
16,402 Posts
Your setup looks great. Would you recommend the normal sized light bar or the large? Smoked or clear?

I've always used the Large Light Bar and have been happy with it. Being larger it should get noticed more or at least thats what i hope.

When i ordered for the FJR I ordered a smoke cover but got clear. Kinda glad they sent the clear should be easier to see.
 

·
Premium Member
Joined
·
16,402 Posts
OK, my lightbar arrived in the mail and I looked at your video again. What did you mount the bar on? It just says it's under the topcase rack, but it's hard to see in the video. Do you have a daytime picture of your mount that you could post? Thank you very much.

Don't have any old photos of it mounted under the topcase. It's attached to a couple of the bolts on the Givi Rack mount plate. I didn't care for this position because it blocked some of the stock back brake light. I like it attached at the license plate as you can see in the above photos for the Versys and FJR.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top