Kawasaki Versys Forum banner
1 - 2 of 10 Posts

· Registered
20 Posts
Discussion Starter · #6 · (Edited)
Just FYI with these, they have a pretty slick powder coat on them including the inside of the riser where the bar goes.

I ended up using a dremel to rough up the inside so that the bars would stay firmly positioned.

I just cut shallow groves similar to the groves already on the bars, works fine now.

This are not adjustable, but the risers are already angled back a bit, so these just continue on that angle. so they end up being up a bit and back towards you a bit. maybe 3/4 of an inch each way. Just enough to make a difference to me. I've done one ride with them and I could tell the difference. Less pressure on my wrists.
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.