Kawasaki Versys Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Also solder rather than just twist all connections and wrap with electrical tape. When soldering heat the wires to be soldered until solder touching the wires (and not the soldering iron) melts into the wires. Installing a 20A fuse between battery and relay is a good idea. Twisted wire connections tend to be a source of power loss and possible failure point.

This is an EXCELLENT point. Run voltage drop tests on several different electrical farkles, and note the differences between clean connections and weathered, twisted-wire connections. You might be very surprised at the results.

:thumb:
 
1 - 1 of 1 Posts
Top