Ravetech bash plate
I installed the Ravetech plate a few months ago on my Gen 2. The plate itself is aluminum and the 2 mounting brackets are steel, all powder coated black. I would say the construction is robust, and I've seen the Motech bash plate and would say it's not better, though some would disagree. I particularly don't like the point on the front of the Motech plate, it seems destined to hit something hard where - in theory - the Ravetech might slide over the same obstacle.
There are 3 instances where I have miscalculated my route on rock-laden hillsides and landed on the plate, and while the plate itself had a couple minor dings, the rear bracket buckled at the bend - which is where you would expect it to bend - and no damage was done to the bike at all. It did not contact the engine, exhaust or oil filter. One hit was almost dead on the oil drain, and I suspect the Ravetech plate prevented a long walk home. Once home, I simply removed the plate and rear bracket, pounded out the dents and re-aligned the mount, and all back together and fine. I realize I subject the plate (and the bike) to greater loads that it is probably designed for, so far without permanent or expensive damage.
This is not a full-bike-weight skid plate, but none are for the Versys.
As for the specific question about oil changes, the plate itself must be removed, but the brackets cause no obstruction. There are 4 button head socket bolts holding it on, easily accessed.
One complaint I have is that the socket head fasteners on the rear mount were hit on the rocks, and it peened over one of the heads so I couldn't get the hex wrench in the socket to remove it, and a button head is not conducive to removal with pliers, especially glued in. I have replaced those fasteners with 10.9 hex head bolts so when peened again, I should still be able to get a wrench on the flats.
FYI, it mounts on the lower rear and front engine mounts. I also have GIVI crash bars, which share these mounting locations, so fitting was a little tricky. The plate did come with a variety of spacers, so not a big deal.
I wouldn't hesitate to recommend the Ravetech bash plate, and IMO it looks better than the Motech as well as allowing the belly plastics to stay on, which looks cool. It came with all necessary mounting hardware, but took 3 weeks from Thailand. Any other questions, happy to help.
Ride more, bitch less - secret to good life!
Last edited by PHX_Joe; 02-23-2017 at 06:24 PM.
Reason: Insert 'gen 2' for reference.