Now that it's getting dark earlier it's time to light up the plate. After cutting the tail off and loosing the stock light I decided to make my own LED plate light.

http://i180.photobucket.com/albums/x281/bicyclebob/dsc_0006.jpg

Took about an hour and cost about $6.00 US at Radio Shack.

1) You will have to remove the seat and stop light to access the area under the tail light.
2) Drill a 1/4" hole in the location of your choice.
3) Install an LED snap in holder.
4) Solder a 660 ohm resistor to the long (positive) leg of the LED.
5) Solder the short (negative) leg to the black wire from the stock plate light pigtail and the resistor to the remaining wire.
6) Snap in the LED and plug in the connector, put the tail back on and viola your done!

Bob, got your email and have checked this out. Thanks!
Mark

What does it look like at night? Does it produce enough light to see the plate?

Lights the plate just enough. I'll see if I can get a decent pic.