I haven't looked around anywhere but I thought some of you may have one already and if you could tell me what you think is the best option I'd appreciate it.

I have the Vista Cruise lock and I'm very happy with it. Installation was pretty straightforward and it holds the throttle just like it should. Actually, I need to tighten mine up a bit, but other than that, it does a good job.

I used a Crampbuster for a good while, but I did not like the fact that it got in my way when I did not want to use it (like around town). I always meant to trim it down so it would ride beside my hand, but I never did.

BTW, there are a few different models of the Vista lock. I used the one that is for all bikes except Yamahas. It's a bit different from the true "universal" model that they make. I think the universal one is a bit more bulky if I recall.

i run the universal vista cruise...it's a little bulky but i'm use to it know, happy so far

http://i260.photobucket.com/albums/ii30/Macvalk/IMG_2110.jpg

This is my set up, Vista cruise and throttle rocker. Took top bolt out of throttle housing, small hex spacer, new longer stainless bolt. It was the only neat way I could find to get it on there.

Machog

I tried the cramp buster but I can't even get myself to ride with it for a couple minutes. I HATE how slippery it is. I squeeze the grip on the outside, and the CB is really slippery plastic. I think they should coat it with a rubbery skin to make it grip your glove better. I was being cheap when I ordered the CB.

I have the Vista- Cruise, and it works great!!! I put them on all of my bikes.

Todd

I have the Throttlemeister, and it works just fine. Now if I could just figure out how to use it with hand guards . . . . - Hank.

Kaoko installed. Works great!

I also have the Vista Cruise. Works as well as any throttle lock.

I have the Kaoko, exactly what i was looking for.
http://www.kaokousa.com/

will the kaoko or throttlemeister work with the barkbuster handguards? Machog which vista cruise do you have?

Machog which vista cruise do you have?

jm, this is what I have, didn't get it from here, got it from my local dealer.

http://www.cajuncycleacc.com/item192.htm

Haven't checked, but assume Versys has the standard 1" bar diameter, I took it off my Valkyrie, KLR 650, it was fine on both of those.

Machog

I have the Vista Cruise. It works great, its inexpensive, and doesn't interfere with

the hand guards.

Mike

jm, this is what I have, didn't get it from here, got it from my local dealer.

http://www.cajuncycleacc.com/item192.htm

Haven't checked, but assume Versys has the standard 1" bar diameter, I took it off my Valkyrie, KLR 650, it was fine on both of those.

Machog

Standard bar diameter's 7/8". For the big cruisers it's 1".