Kawasaki Versys Forum banner

Handlebar measurements for a 2014

4K views 8 replies 5 participants last post by  Beezerboy 
#1 ·
Does anyone have the handlebar measurements (width, Rise, Pullback) for the stock handlebars? Or any recommendation for bars that have another 1" pull back? What I am looking for is a set of bars that have about another 1" of pull back. Yes I have adjusted them to every imaginable way. Bike master sells bars, but I am asking the wisdom of thee group before spending any money and time on this. Thanks in advance!~
 
#2 · (Edited)
Simple solution: ROX pivot risers

This is my set-up, LOTS of adjustability.
Another angle showing the Motowerk riser also installed:
 
#4 ·
#5 ·
If I remember right from 3 years ago, there was a slight adjustment with the cables/wires but nothing too major. Just make sure you turn the bars lock to lock after the installation to check for binding or tightness. I have aftermarket braided steel brake lines on as well so that helps.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top